Announcement

Collapse
No announcement yet.

Using quad 6.6 vacuums with the Mosmatic 21 air recovery surface cleaner

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Using quad 6.6 vacuums with the Mosmatic 21 air recovery surface cleaner

    Question: Dear Donald
    I'm using 21" mosmatic surface cleaner with AZ88.
    The AZ88 located in the van about 2 meter height and I use 100 ft 2" hose.
    I would like to improve the vacuum and want to purchase 4* lamb 6.6 motors.
    Please tell me if the quad 6.6 motors series/parallel system will work well with 21" surface cleaner.
    One more question: the surface cleaner is equipped with plastic ring. Is the brush ring in the bottom will improve the vacuum?
    Best Regards
    Michael

    Answer: A quad lamb 6.6 vacuum system would easily run a 21" surface cleaner. The brush ring will improve cfm air flow into the tool. The cfm is what picks up the water. I would think that with a plastic boot ring you would find it difficult to move the surface cleaner with the vacuum created by quad 6.6 vacuum motors. It is going to need to be able to breath. You will be able to run your tool at least 60 meters!

    Links:
    Goliath Quad 6.6 extractor
    http://www.steam-brite.com/dristorm-...n-p-79456.html

    Mosmatic 21" air recovery
    http://www.steam-brite.com/mosmatic-...ng-p-9143.html

    6.6 motors
    http://www.steam-brite.com/advanced_...words=lamb+6.6
    Last edited by Donald; October 15th, 2014, 05:27 AM.
Working...
X