Question: I need a new vac motor for a mytee 3 stage 500 psi 240 volt unit with two motors.
Part # in my machine is Ametek lamb 117123-00. Couldn't find one in the parts section but read about the A/lamb 6.6 240 volt 12236-18 as a replacement. Can one of these run in conjuction with the other A/lamb motors?
Or is there a better option you would recommend?
Also need a brass pressure regulator repair kit for 200-500psi part 250-33a.
Your help would be greatly appreciated.
Kind regards
Answer: Please visit
This is the actual motor currently used by Mytee in all there 240 volt machines.
Please note to switch to the 6.6 vacuum motor means increasing the amp draw up to another 2 amps @ 240 volts.
This might not be wise or might be OK. I am not familiar with amp availability in other countries. If you have a heated machine, I would not recommend switch. If you do not have a heated machine, you could do a switch but please note that I cannot confirm the installation requirements as far as whether or not it will fit with ease or if the mounting hardware needs to be altered.
Part # in my machine is Ametek lamb 117123-00. Couldn't find one in the parts section but read about the A/lamb 6.6 240 volt 12236-18 as a replacement. Can one of these run in conjuction with the other A/lamb motors?
Or is there a better option you would recommend?
Also need a brass pressure regulator repair kit for 200-500psi part 250-33a.
Your help would be greatly appreciated.
Kind regards
Answer: Please visit
This is the actual motor currently used by Mytee in all there 240 volt machines.
Please note to switch to the 6.6 vacuum motor means increasing the amp draw up to another 2 amps @ 240 volts.
This might not be wise or might be OK. I am not familiar with amp availability in other countries. If you have a heated machine, I would not recommend switch. If you do not have a heated machine, you could do a switch but please note that I cannot confirm the installation requirements as far as whether or not it will fit with ease or if the mounting hardware needs to be altered.