No announcement yet.

Hooking my personal pressure washer with my shop vac

  • Filter
  • Time
  • Show
Clear All
new posts

  • Hooking my personal pressure washer with my shop vac

    Question: Mytee: Redline 12in Tile & Grout Spinner Wand (8904 T-Handle) 1-1/2 Pipe (High profile Low stock) [8904 H]
    I am looking to purchase the following product to regularly clean a 1000 square foot travertine tile patio. As of now I use a pressure washer with a cheap surface cleaner and then use a Home Depot wet/ dry vac to finish the job. I would like to know if I can use the above product to hook up to my existing pressure washer and wet dry vac? Thanks

    The wand you requested is no longer in production and is sold out.
    Please visit
    The above wand will allow you to clean both inside and outside.
    Most of the small import pressure washers at box hardware stores use a 22 mm water pressure connection.
    I believe you will need the following things:
    a 22mm Swivel X 3/8" Fip connector (about $6)
    BR132 3/8" Mip X 1/4" Mip hex nipple (about $3.03)
    1/4" Female tile cleaning QD (about $9.61)
    AH46 expanded hose cuff if you are using 1.5" vacuum hose
    Long enough pressure hose to reach from the sink to the farthest point on the average job site with a male and female carpet and tile cleaning QD.
    As far as hooking to your shop vac you will need to use 1-1/2" vacuum hose. I have know why of knowing what diameter hose your shop vac uses. Some shop vacs use 1.5", 2" or 2.25" ID vacuum hose. Please note if your vacuum is not auto dump, I would expect you to have to manually dump it every 10 minutes.
    If you have the funds for this transition you can always email use photos of your connections on your pressure washer for confirmation.